Installation Matters of High Pressure Hose Joints
Agnes
2019-08-26 14:59:03
(1) The hose cannot be bent excessively during moving or stationary, nor can it be bent at the root, at least 1.5 times its diameter;
(2) When the hose is moved to the extreme position, it should not be pulled too tightly and should be slack;
(3) Try to avoid the torsional deformation of the hose;
(4) The hose should be as far away as possible from the heat radiation member, and the necessary heat insulation board;
(5) The external damage of the hose should be avoided, such as long-term friction on the surface of the same component in use;
(6) If the hose is excessively deformed due to its own weight, there should be a supporting member.
(2) When the hose is moved to the extreme position, it should not be pulled too tightly and should be slack;
(3) Try to avoid the torsional deformation of the hose;
(4) The hose should be as far away as possible from the heat radiation member, and the necessary heat insulation board;
(5) The external damage of the hose should be avoided, such as long-term friction on the surface of the same component in use;
(6) If the hose is excessively deformed due to its own weight, there should be a supporting member.
Agnes' email:sales02@yc-lok.com
